 |
WPM Weld Nut |
|
Part Number |
Thread Size / Pitch |
Width |
Thickness |
Pilot |
Projection |
||
| Diameter | Height | Width | Height | ||||
| Tol. | Tol. | Tol. | Tol. | Tol. | Tol. | ||
| + 0.1 | + + 0.0 | + 0.15 | + 0.1 | + + 0.0 | + 0.08 | ||
| - 0.3 | - 0.3 | - 0.10 | - + 0.0 | - 0.3 | - 0.08 | ||
| A | B | E | F | G | H | ||
| WPM 03511 | M3.5 x 0.6-6H | 11.0 | 3.0 | 4.6 | 1.12 | 2.14 | 0.64 |
| WPM 04011 | M4 x 0.7-6H | 11.0 | 3.8 | 5.0 | 1.12 | 2.14 | 0.64 |
| WPM 05011 | M5 x 0.8-6H | 11.0 | 3.8 | 5.8 | 1.12 | 2.14 | 0.64 |
| WPM 06012 | M6 x 1-6H | 12.6 | 5.0 | 7.4 | 1.22 | 2.14 | 0.74 |
| WPM 08002 | M8 x 1.25-6H | 15.8 | 5.8 | 9.6 | Tol. ± 0.1 1.50 |
2.92 | 0.89 |
 |
The metric WPM weld nut is a square, piloted projection weld nut for use in through-hole applications. A precision pilot facilitates feeding by locating quickly and positively in the sheet hole. The WPM is also countersunk on both sides to guide the mating part quickly into the threads. Rounded corners ease use in confined areas and the four projections provide proper seating and strong welds. |
 |
|
Material: |
C1010 High-Welding |
Tensile Strength: |
60,000 psi | |
| Quality, Low Carbon Steel |
Yield Point: |
30,000 psi | ||
|
Finish: |
Plain, Unless Specified |
Shear Strength: |
30,000 psi | |
|
Threads: |
ANSI / ASME B 1.1-1989 |
Elongation 2” |
30% Max. |
 |
On the WFM weld nut, the projections are located right on the top of the flange to permit welding to (rather than through) the surface of the component. Three precision projections of uniform height and mass are properly positioned on the flange to assure a weld that leaves the exterior surface of the component virtually unmarred. |
 |
|
Material: |
C1010 High-Welding |
Tensile Strength: |
60,000 psi | |
| Quality, Low Carbon Steel |
Yield Point: |
30,000 psi | ||
|
Finish: |
Plain, Unless Specified |
Shear Strength: |
30,000 psi | |
|
Threads: |
ANSI / ASME B 1.1-1989 |
Elongation 2” |
30% Max. |